2 Stroke Outboard Motor 3.5HP Boat Engine with Water Cooling System CDI 92CM DE

Description

Store category
Sign Up Now !
You may also like
2 Stroke Outboard Motor 3.5HP Boat Engine with Water Cooling System CDI 92CM DE
Product Description
Maximum output
3.5HP
Type
2-stroke
Ignition system
CDI system
Propeller mark
7-1/45-A(inch)
Gear ratio
27/13
Country/Region of Manufacture
Unknown
Short Shaft
40cm
MPN
Does not apply
Brand
Unbranded
overall diameter
92cmx36.5cmx22cm
Transom height
42cm
Full throttle perating range
4000-5000r/min
Speed
10km/h
Starting system
Manual start
Staring carburetion system
Choke start
The engine and the propeller ratio
2:1
Recommended fuel
Regular unleaded gasoline
Built-in fuel tank
1.3L
Fuel consumption per hour
1.5L
Warranty
2 Year
Application
Boat
Color
Black
2 Stroke Outboard Motor 3.5HP Boat Engine with Water Cooling System CDI 92CM DE
Description:
Short Shaft:40cm
Overall length:92CM
Overall wideth:36.5cm
Overall height:22cm
Transom height:42cm
Full throttle perating range:4000-5000r/min
Maximum output:2.5kw(3.5HP)
Speed:10km/h
Type:2-stroke
Ignition system: CDI system
Starting system: Manual start
Staring carburetion system: Choke start
Propeller mark:7-1/45-A(inch)
The engine and the propeller ratio:2:1
Recommended fuel: Regular unleaded gasoline
Fuel to oil ratio: 25:1 （Please be suject to this version, and disregard the manual about this point）
Gear ratio: 27/13
Maximum speed: 10 km / h
Built-in fuel tank: 1.3L
Fuel consumption per hour: 1.5L
Cylinder Scoring is a serious damage,which caused by improper use and will cost you a lot of money to repair the motor.
Don't do the following will avoid cylinder Scoring:
1，start the motor on bank
2, use the motor when it stop coming out of water
Even if you want test the motor, it should be done in the river!
When there is no water coming out from the motor,please stop using it immediately ,then check the impeller of Water pump or check if the water outlet has been blocked.
Notice:
Please add gear oil to the gears before use the motor and replace gear oil after the run-in period(10 hours).(if you do not know how to handle this,please contact us) .our outboard motor doesn't with oil of gear,please prepair it by yourself .Keep in mind that you must add oil on the gear before use !!!
About certification:
We can only provide CE certification, there is no other certification can be provided,thanks for your understanding.
Pay Attention
1.About the noise: all the gasoline machines are noisy, currently we did not test the decibel , but the noise is the same as the motorcycle, so it is a normal phenomenon.
2.The machine itself is lightweight, it can use on boat weight of 100kg or less , load-bearing 4 people, but the speed is certainly not the same whenone person on it or 4 people on it . Customer who has high expectations on speed, please be noticed.
3.It can be marched with inflatable boats, rubber boats or fishing boats.
4.Necessary: you have to prepare a boat-motor stand or Hanging board on your boat.
Two strokes 3.5 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode
STRICTLY FOR PROFESSIONAL USE ONLY
Please Note:
There are two pull starter included in the parcel(one is the machine, another one for spare)
We don't supply wearing parts (pull starter)for free.
If you want buy one please contact us
Announcements
After in the sea water or turbid water cruising
1.Use the fresh water cleaning the outboard motor
2.With the moderate velocity circulating the engine,cool off the water chanel with fresh water.
3.Before completely running out cooling water,don't put the outboard motor outside. Otherwise the water cam pass the exhaust port to enter the air cylinder,
from that will cause the engine breakdown.
4.The engine should deposit in the aridity and ventilated well place,avoid exposing directly in the sunshine.
5.Before the long term storing,you should run out of the gasoline in the fuel tank.
Features:
Vertical mount engine design for increased power, performance and durability.
Superior carbonation system with primer bulb for increased efficiency.
Perfect boat engine match inflatable boats, fishing boats, sailboats, etc.
Superior engine air cooling system for improved engine performance.
Durable, lightweight and anti-corrosive construction.
Notice: This machine don't have reverse Button
【About the Noise】: all the gasoline machines are noisy, currently we did not test the decibel , but the noise is the same as the motorcycle, so it is a normal phenomenon.
【Lightweight】: The machine itself is lightweight, it can use on boat weight of 100kg or less , load-bearing 4 people, but the speed is certainly not the same whenone person on it or 4 people on it . Customer who has high expectations on speed, please be noticed.
【Superior Engine】: It can be marched with inflatable boats, rubber boats or fishing boats.
【Necessary】: you have to prepare a boat-motor stand or Hanging board on your boat.
【Notice】: Please add gear oil to the gears before use the motor and replace gear oil after the run-in period(10 hours).(if you do not know how to handle this,please contact us) .
How to use the 2-stroke marine engine:
1. Insert the emergency flameout cable plug into the flameout switch slot
2. Connect the fuel tank to the engine according to the direction indicated by the arrow of the hand core pump.
3. Loosen the air switch on the fuel tank cap counterclockwise.
4. Squeeze the hand core pump several times by hand until the oil circuit is full of fuel and the hand pump feels hard.
5. Set the shift position to the neutral position.
6. Turn the throttle control handle to the start position (ie: the start mark on the handle is aligned with the control arm mark).
7. When the engine is cold, pull out the choke lever (in order to increase the concentration of the combustible mixture and make the engine easier to start). Tip: Cold engine refers to an engine that has not been started for one day or more.
8. Pull the starter handle by hand, quickly pull out the starter rope after the starter engages with the flywheel, and repeat the pullout until the engine is started. Tip: Engagement means that the parts with toothed parts must feel resistance when pulling the starting rope during transmission, otherwise the parts will be damaged.
9. After the engine is started, run the engine at the lowest throttle for 2-3 minutes to warm up the engine, then push the choke lever to the initial position and the throttle to the minimum position. After the engine is started, pay attention to whether the cooling water flows out steadily. If there is no water or intermittent water flow, stop and check the cause.
Payment
Delivery details
Return policy
Feedback
Con-tact us
Payment
We accept PayPal payment only
Payment must be received within 7 days after order is made.
Fees such as import duties, taxes are not included in the item price or shipping costs.
These charges are the buyer's responsibility.
Delivery details
Please pay attention to the payment in advance: according to experience, a transfer takes 2-3 days depending on the bank until the money is over.
As soon as your payment is received, we will send you the goods within 48 hours.
On Saturday and Sunday there is no delivery and no shipping.
Please note: We ship parcels from Germany warehouse to europe buyers!
3-7 days: GERMANY
5-10days: Other countries
We promise that every item has been sent. But sometimes there is also 0.3% package lost during transport . If this happens after we have confirmed this with the post, we will send you the package again as soon as possible or refund the money immediately.
Return policy
Your satis
faction is our ultimate goal. We work hard to earn your trust and future business. Our certified technicians have tested each item before shipping. The unit comes with 1 year limited warranty on all manufacturing defects.
a) If you receive a defective item, Please tell us the problem in details and Please con-tact us within 14 days after you receive the package.
b) What you returned must be intact and in its original packaging as received . Customer is responsible for shipping costs of the returned item caused by misorder,or don't need it anymore.
c) We will cover the cost of shipping if the item is defect when you received. Or We will send you a new unit or refund the full payment you paid.
Feedback
Thanks for buying my business.
If you have any problem with the item, if you have got it, please do not hesitate to contact us.
We will provide you the best solution for any problem with the item.
We would be delighted if you kindly contacted us before requesting a return or leave negative feedback.
Con-tact us
Business Hour
: Monday To Friday: 8:30 AM to 5:00 PM (Beijing China time)
Due to time zones, our reply to your questions may not be immediately. But within above working time, we will reply you-= within 24 hours. If it's non-workdays, please kindly be patient and wait till Monday.
Please con-tact us with ebay message.
Please feel free to con-tact us if you have any questions.
Feedback
On Jul-04-21 at 20:56:07 PDT, seller added the following information: